Banks Power Ford Trucks: (Gas ’87 - 97 7.5L EFI) Powertrain- TransCommand For E40D_4R100 transmissions - Manual (Page 9)

9 p.n. 96370
NOTE: Pin No. 4 hole is not used.
Insert the thin end of the supplied red plastic
wedge into the front of the connector.
Inspect the new connector assembly by double
checking the wire colors and pulling on the
wires from the rear of the connector to be sure they
are fully seated.
plug the new connector into it’s mate on the
Banks Transcommand harness.
Reconnect the transmission control wiring
connector to the transmission.
NOTE: If the connector doesn’t “snap” into position
easily it is possible that the rubber seal that is supposed
to be around the Ford wire loom connector has come
off the plug and is down the transmission socket. If this
has happened, remove the seal with a small pick and
slide it over the red retainer and try again.
Reinstall the heat shield.
Route Transcommand ™ harness along the
transmission crossmember and under the frame
as shown in Figure 1. plug the Transcommand ™
wiring harness into the pigtail connector on the
Transcommand ™ .
using a 10mm socket, remove the right rear
transmission pan bolt. Insert the bolt through
the ring terminal on the end of the black ground wire
and reinstall it in the transmission. See Figure 2.
go over the entire installation, check that
all wiring is properly secured. The Banks
Transcommand ™ installation is now complete. Lower
the vehicle.
NOTE: The following symptoms would indicate a
wiring error. If the “Check Engine” light (or Over Drive
indicator light) flashes, or the transmission appears
to have third gear only, or very harsh shifting occurs,
check the following. Be sure the wiring is correct,
the pins are all fully seated in the connectors and the
connectors are fully mated.
18.
17.
16.
15.
14.
13.
12.
FIgURE 5