Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Programmer- OttoMind Programmer - Manual (Page 12)

12
96526 v.2.0
Section 4
DIAGNOSTIC SECTION
The diagnostic feature on the Banks
OttoMind programmer allows you to
check and clear Diagnostic Trouble
code (DTc) light and assist in
Troubleshooting.
1.
Plug the OBD II connector from your
Banks OttoMind programmer into the
OBDII connection port of your vehicle.
2.
After the welcome screen, scroll
up or down in the main menu screen
and highlight to select ‘Diagnostics and
Info’ and press the ‘ENTER’ button. See
Figure 8.
3.
Scroll through the ‘Diagnostics and
Info’ screen using the up and down
arrow keys to view the options.
4.
Highlight ‘Read DTcs’ and press
the ‘ENTER’ button to select it. See
Figure 9.
5.
Follow the on screen instructions
and turn the ignition key ON, but do
not start the engine, when prompted
by the programmer. Then press the
‘ENTER’ button.
6.
Screen will display any stored DTc.
Highlight any DTc to select it and
press the ‘ENTER’ button to get a more
detailed description. Press the ‘ESc’
button to EXIT.
7.
To remove Diagnostic Trouble
codes press the ‘ESc’ button to return
to the ‘Diagnostics and Info’ menu and
scroll down to ‘clear DTcs’. Press the
‘ENTER’ button. See Figure 10.
8.
Follow the on screen instructions
and turn the ignition key ON, but do
not start the engine, when prompted
by the programmer. Then press the
‘ENTER’ button.
9.
Screen will announce that the
DTcs have been cleared. Follow the
on screen instructions and turn the
ignition key OFF, when prompted by
the programmer. Then press the ‘ESc’
button to EXIT and go to the previous
menu.
10.
To read the family, in the
‘Diagnostics and Info’ menu scroll
down to ‘Read Family’ and press
the ‘ENTER’ button to continue.
See Figure 11.
11.
Follow the on screen instructions
and turn the ignition key ON, but do
not start the engine, when prompted
by the programmer. Then press the
‘ENTER’ button.
12.
Screen will Display 7 digit
designation of calibration version of
EcM (Family).
Note: Only for dealer vehicle reflashes
or if family is unsupported by current
Banks Ottomind Software.
-END, SECTION 4-