Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Speed Control- SpeedBrake '06-07 (iQ) For use with Banks iQ - Manual (Page 14)

14
97239 v.4.0
Note: make sure the fuse box cover
is clean and free of any oil residue and
contaminates. Clean fuse box cover
with a non-oil based solvent such as
Acetone, Mineral Spirits, Denatured
Alcohol or Lacquer thinner. Read and
follow the manufactures operation
instruction for non-oil based solvent
cleanser.
If vehicle is equipped with a Banks
tuner, detach the tuner from the top
of the fuse box cover and reattach on
the fuse box side or on top of the fuse
box along with the SpeedBrake. See
Figure 12 & 13. If placing the tuner
on top of the fuse box along with
the SpeedBrake module there may
be some over hang from the tuner.
Secure the tuner so that it stays in
place. Use the supplied hook & loop
interlocking fasteners to make the
necessary adjustment to attach the
SpeedBrake to the top of the fuse box
cover and Banks tuner to the fuse box
side or top.
WaRNING: Make sure to place the
SpeedBrake Module as shown in
figure 11 to avoid a clearance issue
when closing the hood. Mount the
SpeedBrake Module as close to the
inside edge of the fuse cover as
possible.
22.
Insert the SpeedBrake 20-pin
female connector on the wire harness
to the 20-pin male connector on
the SpeedBrake Module. Using the
supplied cable ties, secure the wire
harness away from any heat sources
(i.e. Driver side exhaust manifold) or
moving components.
23.
Reinstall the driver side cowl
support brace. Tighten the factory
hardware to 80 in-lbs.
-END, SECTION 1-