Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Power Systems- PowerPack & Stinger Systems w Economind (LLY & LBZ) '06-07 (PDA) Compatible w_ Optional PowerPDA User Manual

Page 14

96506 v.8.0

park/turn signal lamp assembly by

depressing the outboard retaining

clip, then rotating the assembly
outward as shown in Figure 2.4.

Remove the bulbs from the turn

signal lamp assembly by turning

the lamp sockets a quarter turn

counterclockwise.
Note: The headlamp is easily
disengaged and does not require
force to be removed once the
outboard clip has been depressed.
Attention: Number and location of

bolts on the headlamp assembly

may vary by model and year.
Note: The inner fenderwell cover
must be removed to access the
bottom bolt. Next, remove the (3
per side) bolts to the head assembly
grill support bracket. Disconnect the
connectors from the backside of the
headlamp assembly from both driver
and passenger headlamp assemblies.
Remove the headlamp assemblies.
Note: Slide the headlamp assembly
toward the center and forward of
the vehicle to remove. The turn
signals are built into the headlamp
assembly.

Remove the plastic headlamp

mounting structure. Remove the

plastic headlamp mounting structure

on the driver and passenger side
of the vehicle shown in Figure 2.5.

There are (6x) bolts, (2x) torx head

bolts, (1x) push-in retainer and (1x)

large clip that must be disconnected

to remove the piece from the

vehicle, per side. The plastic piece

that resides by the bumper must

be detached from the headlamp

mounting structure, but will remain

on the vehicle. The retaining clip

that attaches the hood latch cable to

the support structure must also be

removed on the driver’s side.

Remove the two bolts that secure

the upper fan shroud to the upper

radiator cross brace. Remove the

four push-in retainers (2 per side)

that attach the upper section to the

lower section of the fan shroud.

These retainers are removed by

pulling up on the center pin then

prying the entire retainer assembly
out as shown in Figure 2.2.

carefully remove the transmission

module from the upper fan shroud.

Lay the module to the side. See

Figure 2.6.

Figure 2.4 2006-07 LBZ: Parking Lamp Assembly Removal

Figure 2.5

‘06-07 LBZ: Removal of Headlamp/Parking Lamp Assembly Support Structures.

Figure 2.6 Transmission module