Banks Power Toyota Trucks: (Gas ’00 - 06 3.4, 4.0 & 4.7L Tundra) Exhaust- Monster Exhaust, Single Passenger side exit '00-06 3.4L, 4.0L & 4.7L - Manual (Page 6)

6
97059 v.4.0
9.
Adjust the Tailpipe Tip under the
rear fender such that the tip position is
aesthetically pleasing.
10.
With the exhaust positioned
properly, begin to tighten the clamps
starting with the ones closest to the
front of the vehicle and working your
way back. Torque the V-band clamp to
12 ft-lbs. Torque the remaining exhaust
clamps evenly to 35 ft-lbs. Make sure
that each slip is fully inserted (+/-
1 ⁄ 4 ").
11.
Remove the protective covering
from the tailpipe tip. Caution: the
protective covering may ignite and
burn if not removed prior to
running the engine.
12.
Your system includes two (2)
Banks Power logos designed to
complement the Toyota Tundra
emblems on the vehicles front doors.
Use the provided measurements for a
clean factory look (see
Figure 4).
13.
Re-connect the negative battery
cable. Start the engine and listen for
exhaust leaks. Tighten the exhaust
clamps as necessary. Whenever
possible, tack weld slip connections to
prevent disengagement is
recommended. The Banks Monster
Exhaust installation is now complete.
Figure 4