Banks Power Toyota Trucks: (Gas ’07 - 14 5.7L Tundra) Exhaust- Monster Exhaust, Single Passenger side exit '09-10 Double Cab Standard Bed - Manual (Page 6)

6
97250 v.3.0
7.
Cut the pipe using a hacksaw or
similar electric cutting tool at the mark
location. Take time when measuring and
cutting the factory outlet pipe to ensure
the proper location and a straight cut.
Improper cut will result in poor fitment of
the Banks Monster exhaust system.
8.
Install a 2- 1 /
2
” clamp on the left
factory intermediate pipe outlet.
Install the Banks Y-pipe flange
connection and supplied ring gasket
onto the factory intermediate pipe
flange connection and then insert the
Y-pipe slip joint over the left factory
intermediate pipe. Lightly tighten the
2- 1 /
2
” clamp over the Y-pipe left inlet
and re-use the factory hardware to
tighten the factory flange connection
to the Y-pipe flange.
9.
Locate and install the intermediate
pipe swedged end onto the Banks
Y-pipe outlet. Install a 3” saddle clamp
onto the swedged end and loosely
tighten. Slide on the sliding hanger
clamp onto the intermediate pipe such
that the hanger pins face the rear of
the vehicle. Install the clamp hanger
pins into the corresponding vehicle
rubber insulators and loosely tighten
the clamp.
NOTE: When installing hanger pins into
rubber insulators make sure that the
pin is pushed properly into place. See
Figure 3.
10.
Install the 3” exhaust clamp onto
the inlet of the Banks Monster Muffler
(Note: the inlet labeling of the muffler).
Orient the “Monster” logo such that
it is parallel with the frame rail. Install
the Banks Muffler inlet onto the
intermediate pipe and lightly tighten
the 3” clamp.
NOTE: All clamps should be positioned
at the beginning of the slots (on the 1 ⁄
2
circle punch) and evenly tightened. See
Figure 4.
11.
Install the 3” rear muffler hanger
clamp onto the Banks Muffler outlet
such that the hanger pin face forward.
Install the clamp hanger pin into
the corresponding vehicle rubber
insulators. See Figure 3.
12.
From the vehicle rear, route
the tailpipe over the rear end. Start
the tailpipe hanger pin into the
corresponding vehicle rubber hanger.
Install the tailpipe into the Banks
Muffler outlet. Lightly tighten the rear
muffler hanger clamp to secure the
tailpipe. See Figure 5.
13.
Adjust the Tailpipe Tip under the
rear fender such that the tip position is
aesthetically pleasing.
14.
With the exhaust positioned
properly, begin to tighten the clamps
starting with the ones closest to the
front of the vehicle and working your
way back. Torque the exhaust clamps
evenly to 35 ft-lbs. Make sure that
each slip is fully inserted (+/- 1 ⁄
4
”). See
Figure 4.
15.
Remove the protective covering
from the tailpipe tip.
Caution: the protective covering
may ignite and burn if not
removed prior to running the
engine.
16.
Your system includes two (2)
Banks Power logos designed to
complement the Toyota Tundra
emblems on the vehicles front doors.
Use the provided measurements for a
clean factory look (see Figure 6).