Banks Power Toyota Trucks: (Gas ’07 - 14 5.7L Tundra) Exhaust- Monster Exhaust, Single Passenger side exit '09-10 Double Cab Standard Bed - Manual (Page 3)

97250 v.3.0
3
Monster Exhaust System Installation
1.
Disconnect the negative (ground)
cable from the battery (if there is more
than one battery, disconnect both
negative cables). Secure the cable so
it cannot accidentally come in contact
with the post.
2.
Raise the vehicle and support it
securely with properly weight-rated
safety stands, ramps or a commercial
hoist. Take care to balance the vehicle
to prevent it from slipping or falling.
When using ramps, be sure the wheels
are centered squarely on the topsides.
Place the transmission in park
(automatic), set the parking brake and
securely block the wheels that are on
the ground.
CAUTION: DO NOT WORK UNDER
ANY VEHICLE SUPPORTED ONLY
BY A JACK. SEVERE INJURY MAY
RESULT.
3.
From under the vehicle remove the
factory exhaust bolts located on both
flanged Y-Pipes. Keep the removed bolts.
They will be reused in a later step.
NOTE: Remove the factory gaskets. The
exhaust system will be hanging by the
hanger clamps.
4.
Liberally apply an aerosol lubricant on
all the hanger pins. Remove the exhaust
system from the vehicle by removing
each hanger pin from the rubber
insulator.
NOTE: Remove pins from front of vehicle
to rear.
5.
Drop the exhaust system to the floor
and move out of the way. You will not
be reusing any components from the
exhaust system.
WARNING! The following steps
may require the use of a torch and/
or saw. Proper safety equipment
should be used. Failure to use
proper safety equipment may
result in severe injury.
6.
Measure 16- 1 /
4
” from the left flange
connection forward following the
right side of the pipe and marking the
location on the left factory intermediate
pipe as shown in Figure 1.
Figure 1