Banks Power GM Motorhomes: (Gas ’01 - 10 8.1L Workhorse) Programmer- Ottomind Programmer '99-07 Chevy-GMC 4.8L, 5.3L, 6.0L, 8.1L Trucks '01-07 Chevy-GMC 8.1L WorkHorse Class A Motor Home - Manual (Page 4)

Familiarize yourself with Banks
OttoMind keypad controls. The
keypad will allow the user to navigate
between screens and to select
functions. (See Figure 1).
Preparation and
Precautions
WARNING: The Banks OttoMind
Programmer will NOT work
with 2003 GM ECMs with an
Intel chip. Locate the ECM and
look at the weather stripping
gasket on the ECM housing.
If the weather stripping is
reddish-orange, then the ECM
has an Intel chip and the
Programmer will not work.
1.
Do not activate any electrical
accessories while installing the Banks
OttoMind Performance tune. Ensure
that there are no electronic devices
wired or plugged into the vehicle that
can cause a substantial voltage drop,
which can be activated during the
installation of the Banks OttoMind
Performance tune. Please contact
a Banks dealer if uncertain about
devices that are on your vehicle.
2.
certain cellular phones or
radio equipment might also cause
interference, please remove or turn
such devices off.
3.
Ensure that the vehicle battery
voltage is correct. charge your battery
if necessary.
Note: Do not attempt to install the
Banks OttoMind performance tune on
a vehicle with a insufficiently charged
battery.
4.
Unless instructed in the installation
steps, never turn the ignition key OFF
while the Banks OttoMind is plugged
into the OBDII connection port.
Warning: Unplugging the Banks
OttoMind Programmer while
uploading or downloading
a program can damage the
vehicles ECM.
5.
Ensure that the factory “stock”
tune is in the vehicle’s EcM before
installing the Banks OttoMind. If you
are uncertain if your vehicle has the
stock tune then have the vehicle’s
EcM reflashed by a GM dealer.
Note: GM dealer re-flashes are the
same as stock factory tune.
WARNING: The Banks OttoMind
should not be installed over
a nonfactory/aftermarket
performance tune, and cannot be
used in conjunction with other
tuning devices such as chips or
plug in modules of any kind.
connecting to oBD ii
6.
Locate the OBD II connection port
in your vehicle. The OBD II connection
port is located under the dash panel
and can be located on either side of
the steering wheel.
7.
connect your Banks OttoMind
programmer to the vehicle OBD II
connection port.
Note: When the OBD II connector
is plugged, the Banks OttoMind will
automatically power on and illuminate
its screen. If the Banks OttoMind does
not come on then check the fuse to
the cigarette lighter in the fuse panel.
The screen will display the Banks
OttoMind (See Figure 2), Then display
the ‘Main Menu’.
-END, SEcTION 1-
4
96343 v.6.0