Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Intake- High-Ram Air Intake '03-07 - Manual (Page 8)

8
96768 v.8.0
11.
If your vehicle is NOT equipped
with a factory ground strap on the
intake heater, install the supplied
ground strap from the intake heater to
the engine. Put a 6-mm washer onto
the bottom intake heater stud, leaving
the factory heater nut installed. Next,
install the smaller diameter ground
strap terminal over the stud and retain
with a 6-mm washer and nut. Route
the other end of the ground strap to
the threaded section on the engine
and retain with a SAE washer and
M8-1.25x 16 bolt. See Figure 2.
12.
Using a flat screwdriver, loosen
the clamp that holds the rear injector
wire harness on the engine valve
cover. Disconnect the injector wire
harness from its connection. See
Figure 3. Remove the bracket used
to hold this wire harness to the stock
ram. Route this harness underneath
the heater harness and around the
fuel by-pass valve as shown in Figure
4. Place the wire harness back in the
clamp that is on the valve cover and
re-connect the wire harness. Make
sure there is no sharp bending in
the wire harness, and secure it by
re-fastening the clamp. Secure the
wire harness with the supplied cable
ties.
13.
Disconnect the MAP and the
FRP sensors and relocate the wire
harness in front of the heater harness
as shown in Figure 4. Reconnect the
sensors.
Figure 5