Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Intake- Ram-Air Intake System '99-03 - Manual (Page 13)

96885 v.3.0
13
19.
Locate the Banks Air Filter and
Filter Hose clamp. Place the Air Filter
hose clamp on the Banks Air filter. Do
not tighten the clamp.
WARNING: Filter may come
loose at connection point due to
oil residue. Clean the air filter
connection points with a non-oil
based solvent such as Acetone,
Mineral Spirits, Denatured
Alcohol, or Lacquer Thinner. Read
and follow the manufactures
operation instruction for non-oil
based solvent cleaner. Be careful
not to apply cleaner to cotton
filter media or damage to media
may result.
20.
Attach the Banks Air Filter to the
Banks Intake Tube. Hand tighten the
Air Filter clamp.
21.
Insert the Banks Intake Tube to
the air inlet tube making sure the Hose
and Hose clamps slide into place.
22.
Drop the Banks Intake Tube with
Air Filter into the air filter housing and
align the tubing with the filter housing.
See Figure 9.
23.
Hand tighten the hose clamps at
the air inlet tube and the air filter.
24.
Insert the Air Filter Minder into
the Intake tube.
NOTE: Route the Air Filter Minder
and wiring under the intake tube to
properly install in place. If necessary
disconnect the Air Filter Minder from
the wiring connector.
25.
Place the battery into place
making sure that it sits properly into
the Banks Air Filter Housing assembly.
26.
Install the battery retainer bolt
into place and secure the battery.
27.
Reconnect all battery
connections.
28.
Locate the Air Filter Housing
cover and place over the filter. Secure
with the supplied screws. You have
successfully completed the installation
of the Banks Ram-air Intake system.
Make sure to go over all hose clamps
for tightness and connectors for a
secure fit. See Figure 10.
-EnD, SECTIon 2-
Figure 10