Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Intake- Ram-Air Intake System '99-03 - Manual (Page 11)

96885 v.3.0
11
10.
Remove the factory battery tray
and air filter box assembly from the
vehicle.
11.
From the air filter box assembly
remove the factory Air Filter Minder
rubber grommet.
12.
Locate the Banks Intake tube and
Install the factory Air Filter Minder
rubber grommet. See Figure 7.
NOTE: For Vehicles without a factory
Filter Minder, insert Banks Filter
Minder Plug into hole on the Banks
Intake Tube if your vehicle does not
come equipped with a Filter Minder.
13.
Locate the Banks Air Filter
Housing assembly. Install the supplied
Edge Grip seal around the side opening
facing the left side of the vehicle.
14.
Install the supplied retainer plate
and screws to the back of the Housing
assembly. Insert the IAT sensor into
the Air Filter Housing assembly.
15.
Install the Banks Air Filter
Housing assembly into place. Make
sure to align the side air inlet opening
to the vehicle frame opening. connect
IAT sensor connector if previously
disconnected.
NOTE: Route all wiring so that it is not
obstructed by the Air Filter assembly.
16.
Locate the supplied bolts and
secure Banks Air Filter Housing
assembly into place. See Figure 8.
The two short bolts will go over the
holes on the bottom of the Housing
assembly. The longer bolt will go over
the front side hole of the housing.
17.
For Vehicles equipped with front
fresh air inlet tube, connect the fresh
air inlet tube to the air filter housing
assembly. See Figure 8.
NOTE: Earlier production models may not
be equipped with fresh air inlet tube.
18.
Locate the Hose and Hose
clamps. Install the Hose onto the
outlet of the Intake tube and secure
in place with the Hose clamps. See
Figure 7.
Figure 7