VANCO WM2342T - Manual (Page 4)

-4-
Part 1b-Concrete Wall Mounting
.
Level wall plate(1) and use wall as a template to mark six holes. Drill six 3/8
(10mm) dia. holes 2 (50mm) deep. Insert six anchors(I) into holes and
secure wall plate with six long bolts(H) and six washers(J).Tighten screws
firmly. Do not overtighten ”
”
Part 1b-Concrete Wall Mounting
Concrete Wall
I
2 ( ” 50mm)
Φ3/8 (10mm) ”
H
J
Bubble level
-5-
.
Part 2a-Attaching Brackets To Screen With Flat Back
Center brackets vertically on back of screen. Select the small(A or B),medium
(C) or large(D). Attach brackets to screen using four selected screws and four
square washers(G) at the top and bottom of each bracket. Tighten screws
firmly. Do not overtighten
Part 2a-Attaching Brackets To Screen With Flat Back
G
A-D
Square washer(G)
Small hole for
M4 screws
Medium hole
for M5 screws
Large hole for
M6 screws
TILT ADJUSTER
KNOB MUST
FACE OUT
UP
UP