Velleman LX103 - Manual (Page 7)

LX103
V. 04 – 11/12/2013 7 ©Velleman nv
Custom Static Colours
This device allows you to create custom static colours.
1. Press
is displayed.
2. Press to confirm your selection.
3. Use or to select the desired colour.
4. Press enter to change the red colour value (
~ , from 0 to 100%).
5. Press to confirm and to move to the next colour (green, blue). Set the value for the
second and third colour.
7.4 Master/Slave Mode
This mode allows control several units simultaneously.
1. Use standard DMX cables to daisy-chain your units together via the DMX connector on the rear of
each fixture. For longer cable runs we suggest using a terminator on the last fixture.
2. Choose the first unit in the chain to function as the master fixture. Press
mode ( , or ).
3. On each of the connected slave units, set the same channel mode as the master (via ).
Chasing Mode
This mode allows multiple units to run in sequence.
1. Press
is displayed.
2. Press to confirm your selection.
3. Use or to select
or .
4. Press to confirm your selection.
5. Use or to select the position of the device in the chase:
o
On the master, set the position to
o
On the slaves, set the position to ~ depending on the physical layout of the
chain.
Note: for older devices revision 1.0, set the master to address ; set version 2.0 slaves to
~ .
7.5 DMX Mode
This mode allows you to control the fixture by any universal DMX controller.
• All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This digital start address is the channel number from which the device starts to “listen” to
the DMX controller. The same starting address can be used for a whole group of devices or an
individual address can be set for every device.
• When all devices have the same address, all the units will “listen” to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set individual addresses, each device will “listen” to a separate channel
number. Changing the settings of one channel will only affect the device in question.
Example:
o
In case of the 9-channel LX103, you will have to set the start address of the first unit to 1
(CH1~9), the second unit to 10 (1 + 9) (CH10~18), the third to 19 (10 + 9) (CH19~27), and
so on.
1. Press , , , , ,
, or ) is displayed.
2. Press to confirm your selection.
3. Use or to select the desired DMX starting address (
~ ).
DMX Channel Values
3-Channel Mode
channel function from to description
1 red 000 255 dimmer 0 ~ 100%
2 green 000 255 dimmer 0 ~ 100%
3 blue 000 255 dimmer 0 ~ 100%