Velleman CAMCOLVC11 - Manual (Page 5)

CAMCOLVC11
21.09.2010 5 ©Velleman nv
Save this file. Date and time will come into effect after reboot.
Note: stop the USB device in the appropriate way before disconnecting
from the USB port.
Using the camera
• Press and hold the on/off button [c] until both red and green status LEDs
[b] are on. When initialization is finished, the red LED turns off while the
green remains lit. The camera is now in standby mode.
• Shortly press the record button [c] to start recording videos. The green
status LED [b] flashes 6 times, than switches off. The camera is in
continuous recording mode.
Note: do not point the camera lens [a] towards intense light sources e.g.
direct or indirect sunlight or highly reflective surfaces.
• To end continuous recording mode, shortly press the record button [c]
again. The green status LED [b] is on.
• To enter motion detection mode, press and hold the motion button [d]
until both green and red status LEDs [b] flash simultaneously 6 times. The
red status LED [b] flashes once when motion is detected. The camera stops
recording when motion is not longer detected.
• To end motion detection mode, shortly press the record button [c]. The
green status LED [b] is on.
• To take a snapshot, shortly press the snapshot button [d]. The green status
LED [b] shortly turns off, than on again.
• Switch off the camera by pressing and holding the on/off button [c]. The
red and green status LEDs [b] flash 3 times simultaneously.
Connecting to a PC
• Switch off the camera.
• Connect the included USB cable to the USB port [g] and insert the other end
into a USB port of a computer (not incl.).
• The status LEDs [b] will light up green (+ slowly flashing red LED during
charging) and the device will now act as a regular USB memory device.
Copy, open or delete the recordings as you would with other files on your