Velleman DVR16H1 Quick Installation Guide - Manual (Page 7)

DVR16H1
14/04/2011 © Velleman nv 7
• Press the MENU button and enter the password to go into the menu list.
• Select the QUICK START menu item.
• Select the GENERAL menu item using the NAVIGATION button.
• Set the image size, image quality and images per second for recording.
• Refer to the full user manual on the included CD-ROM for more details.
Audio playback
• Press the SLOW and ZOOM button simultaneously to select the desired audio channel or use the
quick menu bar (see below). The current audio channel is indicated in the status bar.
Switch users
• The DVR can be accessed as administrator ( ) or operator ( ), icons are indicated in the status
bar.
• To switch between users, click on the user icon ( or ) to lock the current session ( ).
• Press on the key lock icon ( ) than enter the password of the desired profile.
Video output
• When both a CRT monitor and a VGA screen are connected at the same time, by default, the DVR
will automatically revert to the VGA screen.
• To switch to the other display, go to ADVANCED CONFIG and set the DISPLAY OUTPUT PATH.
Note: the DVR must be reset for the setting to take effect.
• It is also possible to select a display at start-up of the DVR. Press the left key ( ) on the front
panel during start-up to use the CRT monitor; press the right key ( ) during set-up to use the
VGA output.
8. Operation
Display
The following image shows the screen layout.
A system date and time
B general system status
C available HDD capacity
D channel status
live audio channel 1 .. 4 enabled
playback audio channel 1 .. 4 enabled
(yellow)
audio channel disabled timer recording
digital zoom on (yellow) / off USB mouse connected
LAN connected / Internet connected / no network connection
USB flash drive connected Hard disk overwrite (default)
key lock on PTZ mode
sequence mode motion mode