Velleman DVR4MQAE - Manual (Page 16)

DVR4MQAE - 16 - VELLEMAN
3. ID:
Set the ID number (0 ~ 255) as the ID of each device.
4. PROTOCOL:
Select NORMAL or PELCO-D protocol. The baud rate = 2400 bits/sec.
5. RATE:
Set the baud rate of each channel (2400, 4800, 9600, 19200, 57600).
PTZ Control:
1. Device: PTZ / Pelco-D protocol PTZ.
2. Connection (RS485): Refer to rear panel / Refer to PIN configuration (see Appendix #2).
3. Detailed Instructions: Refer to PTZ manual.
k.
Advance Menu: SYSTEM
Move the cursor to the “SYSTEM” and press ”ENTER”. The screen will show the following options:
1. SERIAL TYPE:
Press “ENTER” or “＋” or “－” button to set the control serial type (RS-485, RS-232) of DVR.
2. BAUD RATE:
Press “ENTER” or “＋” or “－” button to set the BAUD RATE of DVR (2400, 9600, 19200, 57600).
3. HOST ID:
Press “ENTER” or “＋” or “－” button to set the ID of DVR (0 ~ 255).
4. PASSWORD:
Press “ENTER” or “＋” or “－” button to set the password for accessing DVR.
5. RESET DEFAULT:
Press “ENTER” and select “YES” to confirm or “NO” to cancel.
6. CLEAR HDD:
Press “ENTER” and “YES” to clear HDD or “NO” to cancel. In this function, you can press “＋” or “－” to select
the MASTER HDD, SLAVE HDD or DISK ARRAY which you plan to clear.
7. UPGRADE:
Press “ENTER” and select “YES” to confirm upgrade or “NO” to cancel.
8. AUTO KEYLOCK:
Set the auto key lock function (Never / 10 sec / 30 sec / 60 sec).
9. LANGUAGE:
English only.
10. VERSION:
The firmware version information will be shown on the screen.
11. VIDEO FORMAT:
The information of the DVR’s video format will be shown on the screen.
SYSTEM
SERIAL TYPE RS-485
BAUD RATE 02400
HOST ID 003
PASSWORD 0000
RESET DEFAULT RESET
CLEAR HDD MASTER
UPGRADE NO
AUTO KEYLOCK NEVER
LANGUAGE ENGLISH
VERSION 1030-08-H3-04-V354-07
VIDEO FORMAT NTSC