Velleman VDPL710MHW14x - Manual (Page 6)

VDPL710MHW14B/VDPL710MHW14W
V. 01 – 26/03/2013 6 ©Velleman nv
Colour Adjustment
You can adjust the brightness of the red, green, blue, and white LEDs to set the desired output colour.
To adjust the colour:
1. Press once to enter menu mode ( is displayed).
2. Press and hold for about 5 seconds until is displayed.
3. Press again.
4. Use and to select the LED colour that you want to adjust: for the red LEDs,
for the green LEDs, for the blue LEDs, and for the white LEDs. Press
to confirm.
5. Use and to set the brightness (0-255) of the selected colour and press to
confirm.
6. Press to quit.
Standby Mode
If you are working with a DMX controller, the signal cable may be (accidentally) disconnected, or the
controller may be (accidentally) switched off. In this case, you can define how the device responds:
either the device stops (stand-by), or it starts running the built-in program.
1. Press until is displayed and press .
2. Use and to select the desired setting:
o : the device stops if there is no DMX signal.
o : the device starts running the built-in program if there is no DMX signal.
3. Press to confirm.
Reset Position
It may happen (for example because of a power surge) that the device deviates from the correct neutral
pan/tilt position (pan and tilt = 0°).
To reset the moving head to the correct neutral position, press until is displayed
and press . The moving head corrects its position.
Test Mode
You can run a test programme to check if all LEDs are functional.
1. Press until is displayed and press .
The device runs a test programme. During the test, “test” blinks on the display.
2. Press to quit.
Operation Time
The device counts the time the lights have been operational.
1. Press until is displayed and press .
The display shows the operation time in hours.
2. Press to quit.
7.3 Stand-Alone Mode
In stand-alone mode, the device runs a built-in program: automatic or sound-activated.
To set the device to stand-alone mode:
1. Connect nothing to the DMX input [3] of the device.
2. Press until is displayed and press .
3. Use and to select and press to confirm.
4. Press until is displayed and press .
5. Use and to select the desired setting:
o : the device runs the built-in program.
o : the device operates as a master device in sound-activated mode.
6. Press to confirm.
Setting the Microphone Sensitivity
For sound-activated mode, you can adjust the sensitivity of the internal microphone. To change the
sensitivity of the internal microphone, proceed as follows:
1. Press until is displayed and press .
2. Use and to change the sensitivity (0-100) and press .