Velleman VASMON2N - Manual (Page 2)

VASMON2N VELLEMAN - 2 -
VASMON2N – VIDEO TO VGA CONVERTOR
1. Introduction & Specifications
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to
a specialized company for recycling. This device should be returned to your distributor or to a local
recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, don't install or use it and contact your dealer.
Connections
DVR monitor out
Monitor D-sub
Output Resolution 1024 x 768 @ 60Hz or 1280 x 1024@60Hz (selectable)
Power Consumption 2.5W
Power Supply 12VDC/500mA adapter (incl.)
Dimensions 87 x 64 x 24mm
Analogue non-interlaced RGB output, NTSC/PAL system auto detection
2. Installation
Connect the VGA connector (a) to the D-sub
connector (A) of the VASMON2N.
Connect the RCA plug of the VASMON2N (B)
with the RCA output (b) of the DVR.
Connect the regulated power adapter (c) to the
VASMON2N (C).
Locate the pinhole on the back of the unit.
Gently press with a paper clip inside the
pinhole to set the resolution. The selected
resolution is shown on the LCD monitor.
For more info concerning this product, please visit our website www.velleman.eu.
The information in this manual is subject to change without prior notice.