Operation, Settings on the monitor – Velleman SCAMSET User Manual
Page 7
SCAMSET
V. 02 – 30/10/2013
7
©Velleman nv
3. Connect the wires to the monitor and electrical lock as shown on the wiring diagram.
4. Attach the bracket as shown, using the included wall anchors and screws.
7.
Operation
•
When a visitor presses the call button on the outdoor camera, the bell tone sounds and the display
switches on.
•
Press
to speak to the visitor.
•
Press
to open the door.
•
When you have finished speaking to the visitor, press
again.
The display switches off automatically.
8.
Settings on the Monitor
8.1
Menu Settings
On the menu of the monitor, you can change the following settings:
•
Brightness: sets the image brightness.
•
Contrast: sets the image contrast.
•
Saturation: sets the image saturation.
•
Audio: sets the volume on the monitor.
To adjust the volume on the intercom, use the potentiometer on the back panel of the monitor.
Using the menu
•
To switch on the monitor, press the doorbell on the outdoor camera.
•
On the monitor, press
to enter the menu.
•
Press
to select the setting you want to change.
•
Press
or
to change the setting.
•
The menu disappears automatically after a few seconds.
Reset
To reset all settings:
•
On the monitor, press
to enter the menu.
•
Press
to select Reset.
•
Press
or
to reset the device.
Exit
The menu disappears automatically after a few seconds.
You can also exit the menu manually, as follows:
•
Press
to select Exit.
•
Press
or
to exit the menu.
8.2
Button Settings
Bell tone
The monitor has several bell tones.
Press
to browse through the tones and set another tone.
Mute
•
Press
to mute the bell.
•
While mute is active, the
LED on the device flashes.
•
When someone calls at the door, the display switches on without a bell
tone.
•
Press
again to cancel mute.