Milton CAT 24M - Manual (Page 14)

14 24M Motor Grader Preliminary specifications
Service Refill
Fuel Capacity 1326 L 350 gal
Cooling System 90 L 24 gal
Hydraulic system – total 264 L 70 gal
Hydraulic system – tank 135 L 36 gal
Engine Oil 60 L 16 gal
Transmission Oil 38 L 10 gal
Differential/Final Drives 184 L 49 gal
Tandem housing (each) 322 L 85 gal
Front wheel spindle bearing 4 L 1 gal
housing
Circle drive housing 8.5 L 2.3 gal
Weights
Gross Vehicle Weight – base
– total 62 456 kg 137,692 lb
– front axle 18 761 kg 41,360 lb
– rear axle 43 695 kg 96,332 lb
Gross Vehicle Weight – max
– total 66 138 kg 145,808 lb
– front axle 19 927 kg 43,931 lb
– rear axle 46 211 kg 101,877 lb
• Base operating weight calculated on standard machine
configuration with 29.5-29 28PR tires, full fuel tank, coolant,
lubricants and operator.
Standards
ROPS/FOPS ISO 3471/ISO 3499
Steering ISO 5010:1992
Brakes ISO 3450
Sound ISO 6394/ISO 6395
• The static operator sound pressure level measured
according to ISO 6394:1998 for a cab offered by Caterpillar,
when properly installed, maintained and tested with doors
and windows closed and hydraulic fan at maximum speed,
is less than 74 dB(A).
• The dynamic spectator sound power level for the standard
machine measured according to ISO 6395:1988 with no
sound suppression package and hydraulic fan running at
maximum speed is 115 dB(A). When machine is equipped
with sound suppression package and hydraulic fan running
at 70% of maximum speed, machine sound measured is less
than 111 dB(A), complying with EU 2000/14/EC requirement.
Blade Range
Circle centershift – right 437 mm 17.2 in
Circle centershift – left 804 mm 31.7 in
Moldboard sideshift – right 1244 mm 49 in
Moldboard sideshift – left 870 mm 34.3 in
Maximum blade position angle 35°
Blade tip range – forward 40°
Blade tip range – backward 0°
Maximum shoulder reach 3228 mm 127.1 in
outside of tires – right
Maximum shoulder reach 3222 mm 126.9 in
outside of tires – left
Maximum lift above ground 634 mm 25 in
Maximum depth of cut 657 mm 25.9 in
Ripper
Ripping depth, maximum 490 mm 19.3 in
Ripper shank holders 7
Shank holder spacing – min 593 mm 23.4 in
Shank holder spacing – max 604 mm 23.8 in
Penetration force 117 720 kg 39,987 lb
Pryout force 263 880 kg 59,373 lb
Tandems
Height 1040 mm 41 in
Width 353 mm 13.9 in
Sidewall thickness – inner 25 mm 1 in
Sidewall thickness – outer 30 mm 1.2 in
Drive chain pitch 76 mm 3 in
Wheel axle spacing 2285 mm 90 in
Tandem oscillation – front up 20°
Tandem oscillation – front down 20°