Cortech CREASEMASTER PLATINUM CREASING SYSTEM - Manual (Page 4)

CM Platinum Machine Diagram
Exit Tray Guide
Magnetic Stop
Laser/PhotoEye
Paper Gate Assembly
Registration Holes for aligning Op side
Side Rail
1.0 CreaseMaster Platinum General Operation
The CreaseMaster Platinum is an impact die score machine that effectively eliminates
substrate cracking experienced with rotary scoring. The CreaseMaster Platinum is micro-
processor controlled, making it easy to set up and program. It has the program ability to
hold a maxiumum of 20 jobs with 10 creases. Inverted and regular scoring can be
accomplished in one pass. The jobs can all be stored and recalled for future use.
Perforations are done between the air feed table and main rollers, producing a straight
perforation, avoiding tail whip experienced on machines that perform the same function
on the exit side. Perforating wheels are offered in a wide range of teeth configurations
and can be quickly changed using the retaining ring pliers supplied with the machine. A
photocell recognizes the lead edge of the sheet and the microprocessor stops the sheet at
the specific location(s) where a crease is required. Pneumatics allows for non-stop,
tireless operation. Finished stock is then delivered to an exit tray.
Please Note:
The
UP Crease must be programmed at least ¾ inches (2 cm) from
the tail of the stock.
The DOWN Crease must be programmed at least 2.5 inches (6.25 cm)
from the tail of the stock.
Page 4