Hyundai H-MS1101 - Manual (Page 16)

H-MS1101 ( www.hyundai-electronics.ru ) 16
Dolby digital setup
DUAL MONO
Stereo: stereo output signal,
L-Mono: left output signal,
R-Mono: right output signal,
Mix-Mono: left and right output average signal.
DYNAMIC
If watching large dynamic scope movie program at night, to select this mode you can reduce the volume to
a very low level, at the same time, to keep the fine details sounds. In this case, this doesn't disturb the
family and keep the quality sounds.
HDCD
You can select the digital filter Off, 1x, 2x. The initial factory setup is Off.
Video setup
VIDEO OUTPUT
OFF: set video output to the composite.
YUV: set video output in analog component video format when connecting to Y/U/V terminals
RGB: set video output in Red/Green/Blue format when connecting to SCART terminals.
Note: If the video setting differs with the physical connection, the TV set may be without picture. In case
of no picture, you can reset the unit, then keep pressing V-MODE button until the picture is OK again.
TV MODE
When VIDEO OUTPUT is set to YUV or RGB, this item is available.
PROGRESSIVE: The component video will be output in the form of progressive scanning.
INTERLACE: The component video will be output in the form of interlaced scanning.
HD MODE
When VIDEO OUTPUT is set to YUV or RGB, this item is available. Select a HD mode: OFF, 720p or
1080i.
Note: Your TV must support HD input and output to make this item available.
COLOR SETTING: