Sony MEX-BT5100 - Manual (Page 21)

21
Sound
* When the unit is turned off.
Customizing the equalizer curve
— EQ3 Tune
“Custom” of EQ3 allows you to make your own
equalizer settings.
1
Select a source, then press (MENU).
2
Select “Sound” c “EQ3 Preset” c
“Custom,” using the joystick.
3
Select “EQ3 Tune” using the joystick.
4
Select the desired frequency range
from “LOW,” “MID” and “HI.”
5
Select the frequency you wish to
adjust.
Adjustable frequency in each range:
LOW: 60 Hz or 100 Hz
MID: 500 Hz or 1.0 kHz
HI: 10.0 kHz or 12.5 kHz
6
Adjust the equalizer curve.
The volume level is adjustable in 1 dB steps,
from –10 dB to +10 dB.
7
Press the joystick.
Repeat steps 4 to 7 to adjust other
frequencies.
To restore the factory-set equalizer curve,
select “Initialize”
c “Yes” in step 4.
Tip
Other equalizer types are also adjustable.
Using optional equipment
CD/MD changer
Selecting the changer
1 Press (SOURCE) repeatedly until “CD” or
“MD” appears.
2 Press (MODE) repeatedly until the desired
changer appears.
Playback starts.
*1 When an MP3 is played.
*2 When MDLP disc is played.
Skipping albums and discs
1 During playback, push the joystick up/down.
BTM (page 12)
EQ3 Preset
To select an equalizer type: “Xplod,” “Vocal,”
“Edge,” “Cruise,” “Space,” “Gravity,” “Custom”
or “Off” (
z
).
EQ3 Tune
See “Customizing the equalizer curve” on
page 21.
DSO
To select the DSO mode: “1,” “2,” “3” or “off”
(
z
). The larger the number, the more enhanced
the effect.
Balance
To adjust the balance between the right and left
speakers: “R10” – “±0” (
z
) – “L10”
Fader
To adjust the balance between the front and rear
speakers: “F10” – “±0” (
z
) – “R10”
Subwoofer
To adjust the subwoofer volume: “+10” – “±0”
(
z
) – “–10”
(“–
∞” is displayed at the lowest setting.)
LPF (Low Pass Filter)
To select the subwoofer cut-off frequency: “off”
(
z
), “125Hz” or “78Hz.”
AUX Level
To adjust the volume level for each connected
auxiliary equipment. This setting negates the
need to adjust the volume level between sources
(page 22).
Adjustable level: “+6 dB” – “±0 dB” (
z
) –
“–6 dB”
To skip Push up/down
album and hold for a moment, then
release.
album
continuously and hold within 2 seconds of
first releasing.
discs repeatedly.
discs
continuously then push again within 2
seconds and hold.
continue to next page t
Disc/Album number
Unit number, MP3 indication* 1
LP2/LP4 indication* 2