VEGA VEGABAR 82 HART and accumulator pack - Quick setup guide - Manual (Page 14)

14
5 Set up with the display and adjustment module
VEGABAR 82 • HART and accumulator pack
46307-EN-131125
The main menu is divided into five sections with the following func-
tions:
Setup: Settings, e.g., for measurement loop name, application, units,
position correction, adjustment, signal output
Display: Settings, e.g., for language, measured value display, lighting
Diagnosis: Information, e.g. on instrument status, pointer, measure-
ment reliability, simulation
Additional adjustments: PIN, date/time, reset, copy function
Info: Instrument name, hardware and software version, date of manu-
facture, sensor features
Note:
For optimum adjustment of the measuring point, the individual sub-
menu items in the main menu item "Setup" should be selected one
after the other and provided with the correct parameters. If possible,
go through the items in the given sequence.
The procedure is described below.
The following submenu points are available:
The submenu points described below.
Setup
Menu item
Measurement loop name
Application
Units
Unit of measurement
Temperature unit
Position correction
Adjustment
Min. adjustment
Max. adjustment
Damping Integration time
Linearization Linearization type
Scaling Scaling 1
Main menu