VEGA VEGABAR 82 4 … 20 mA_HART - Operating Instructions - Manual (Page 11)

11
3 Product description
VEGABAR 82 • 4 … 20 mA/HART
45028-EN-131010
1
2
3
4
5
Fig. 6: Hygienic installation of the CERTEC ® measuring cell
1 Measuring cell
2 Form seal for the measuring cell
3 Gap-free seal for process fitting
4 Process fitting
5 Diaphragm
3.3 Packaging, transport and storage
Your instrument was protected by packaging during transport. Its
capacity to handle normal loads during transport is assured by a test
based on ISO 4180.
The packaging of standard instruments consists of environment-
friendly, recyclable cardboard. For special versions, PE foam or PE
foil is also used. Dispose of the packaging material via specialised
recycling companies.
Transport must be carried out in due consideration of the notes on the
transport packaging. Nonobservance of these instructions can cause
damage to the device.
The delivery must be checked for completeness and possible transit
damage immediately at receipt. Ascertained transit damage or con-
cealed defects must be appropriately dealt with.
Up to the time of installation, the packages must be left closed and
stored according to the orientation and storage markings on the
outside.
Unless otherwise indicated, the packages must be stored only under
the following conditions:
•
Not in the open
•
Dry and dust free
•
Not exposed to corrosive media
•
Protected against solar radiation
•
Avoiding mechanical shock and vibration
•
Storage and transport temperature see chapter "Supplement -
Technical data - Ambient conditions"
•
Relative humidity 20 … 85 %
Installation in hygienic
fitting
Packaging
Transport
Transport inspection
Storage
Storage and transport
temperature