VEGA VEGAPULS 62 (≥ 2.0.0 - ≥ 4.0.0) 4 … 20 mA_HART four-wire Approval according to LPR radio standard - Manual (Page 33)

6 .3 Parameter adjustment
Through the parameter adjustment the instrument is adapted to the
application conditions. The parameter adjustment is carried out via an
adjustment menu.
The main menu is divided into five sections with the following
functions:
Setup: Settings, e.g., for measurement loop name, medium, applica-
tion, vessel, adjustment, signal output
Display: Settings, e.g., for language, measured value display, lighting
Diagnosis: Information, e.g. on the instrument status, pointer,
reliability, simulation, echo curve
Further settings: Instrument unit, false signal suppression, linear-
isation curve, reset, date/time, reset, copy function
Info: Instrument name, hardware and software version, calibration
date, instrument features
Information:
In this operating instructions manual, the instrument-specific param-
eters in the menu sections "Setup", "Diagnosis" and "Additional
settings" are described. The general parameters in these menu
section are described in the operating instructions manual "Indicating
and adjustment module".
You can find in the operating instructions manual "Indicating and
adjustment module" also the description of the menu sections
"D
isplay" and "Info".
In the main menu point "Setup", the individual submenu points should
be selected subsequently and provided with the correct parameters to
ensure the optimum adjustment of the measurement. The procedure is
described in the following.
Each medium has different reflection properties. With liquids, further
interfering factors are fluctuation product surface and foam generation.
With bulk solids, these are dust generation, material cone and
additional echoes from the vessel wall.
To adapt the sensor to these different measuring conditions, the
selection "Liquid" or "Bulk solid" should be made in this menu item.
Main menu
Setup/Medium
VEGAPULS 62 • Approval according to LPR radio standard 33
6 Set up with the indicating and adjustment module
41719
-EN
-120301