VEGA VEGAPULS 68 (≥ 2.0.0 - ≥ 4.0.0) 4 … 20 mA_HART - four-wire - Manual (Page 13)

13
3 Product description
VEGAPULS 68 • 4 … 20 mA/HART - four-wire
36536-EN-121011
ment of plics ® sensors. The adjustment is carried out via PACTware/
DTM by using the integrated USB connection.
You can find further information in the supplementary instructions
"PLICSMOBILE T61" (Document-ID 36849).
The protective cover protects the sensor housing against soiling and
intense heat from solar radiation.
You will find additional information in the supplementary instructions
manual "Protective cover" (Document-ID 34296).
The electronics module VEGAPULS series 60 is a replacement part
for radar sensors of VEGAPULS series 60. There is a different version
available for each type of signal output.
You can find further information in the operating instructions "Elec-
tronics module VEGAPULS series 60" (Document-ID 36801).
Screwed flanges are available in different versions according to the
following standards: DIN 2501, EN 1092-1, ANSI B 16.5, JIS B 2210-
1984, GOST 12821-80.
You can find additional information in the supplementary instructions
manual "Flanges according to DIN-EN-ASME-JIS" (Document-ID
31088).
The antenna impedance cone is used for optimum transmission of
microwaves and for sealing against the process.
You find further information in the operating instructions "Antenna
impedance cone VEGAPULS 62 and 68" (Document-ID 31381).
Protective cover
Electronics module
Flanges
Antenna impedance cone