VEGA VEGAPULS 62 (≥ 2.0.0 - ≥ 4.0.0) HART and accumulator pack - Manual (Page 13)

13
3 Product description
VEGAPULS 62 • HART and accumulator pack
40793-EN-121011
Screwed flanges are available in different versions according to the
following standards: DIN 2501, EN 1092-1, ANSI B 16.5, JIS B 2210-
1984, GOST 12821-80.
You can find additional information in the supplementary instructions
manual "Flanges according to DIN-EN-ASME-JIS" (Document-ID
31088).
The electronics module VEGAPULS series 60 is a replacement part
for radar sensors of VEGAPULS series 60. There is a different version
available for each type of signal output.
You can find further information in the operating instructions "Elec-
tronics module VEGAPULS series 60" (Document-ID 36801).
The accumulator insert VEGAPULS Serie 60 is an replacement part
for radar sensors of VEGAPULS series 60 with integrated accumula-
tor.
You can find further information in the operating instructions "Accumu-
lator insert VEGAPULS series 60" (Document-ID 41033).
The antenna impedance cone is used for optimum transmission of
microwaves and for sealing against the process.
You find further information in the operating instructions "Antenna
impedance cone VEGAPULS 62 and 68" (Document-ID 31381).
Flanges
Electronics module
Accumulator insert
Antenna impedance cone