VEGA VEGAPULS 68 Antenna covers - Manual (Page 8)

8
3 Mounting
Antenna covers • for VEGAPULS 68
33543-EN-131107
3 Mounting
3.1 Mounting preparations
The following tools are required for mounting, depending on the ver-
sion:
•
Hexagon socket wrench, size 4
•
Screwdriver 6 mm
•
Sharp knife
3.2 Mounting steps, solid covers
Proceed as follows:
1. Press the antenna cover with tension band onto the antenna end
1 3 2
Fig. 6: Mounting, antenna cover of plastic PP
1 Antenna
2 Antenna cover
3 Tension band
2. Tighten tension band
Proceed as follows:
1. Loosen the screws on the antenna base and remove antenna
from the sensor
2. Slip O-ring seal, contact ring and retaining ring onto the antenna
cone
Version with plastic PP
Version with plastic PTFE