VEGA VEGAWAVE 61 - two-wire - Manual (Page 13)

1
2
Fig. 5: Flow orientation of the tuning fork
1 Marking with screwed version
2 Direction of flow
In case of horizontal mounting in adhesive products, the surfaces of
the tuning fork should be vertical in order to reduce buildup on the
tuning fork. On the screwed version you will find a marking on the
hexagon. With this, you can check the position of the tuning fork when
screwing it in. When the hexagon touches the seal, the thread can still
be turned by approx. half a turn. This is sufficient to reach the
recommended installation position.
With flange versions, the fork is directed to the flange holes.
1
Fig. 6: Horizontal installation - marking
1 Marking on top with screwed version
In applications such as grit chambers or settling basins for coarse
sediments, the vibrating element must be protected against damage
with a suitable baffle.
This baffle must be manufactured by you.
Adhesive products
Baffle protection against
falling rocks
VEGAWAVE 61 • - two-wire 13
4 Mounting
32250
-
EN
-120418