VEGA VEGAKON 66 with relay output - Manual (Page 24)

Breaking capacity
-
Min. 50 mW
-
Max. 750 VA AC, 54 W DC
If inductive loads or stronger currents are
switched through, the gold plating on the relay
contact surface will be permanently damaged.
The contact is then no longer suitable for
switching low-level signal circuits.
Contact material (relay contacts) AgNi or AgSnO and Au plated
Modes (adjustable)
-
A Max. detection or overfill protection
-
B Min. detection or dry run protection
Switching delay approx. 0.5 … 20 s
Ambient conditions
Ambient temperature on the housing -40 … +70 °C (-40 … +158 °F)
Ambient temperature with operating
voltage >60 V DC -40 … +50 °C (-40 … +122 °F)
Storage and transport temperature -40 … +80 °C (-40 … +176 °F)
Process conditions
Permissible process temperature -40 … +100 °C (-40 … +212 °F)
Process pressure -1 … 6 bar/-100 … 600 kPa (-14.5 … 87 psi)
Conductive of the medium min. 5 µS/cm with 30 mm electrode covering
Electromechanical data
Cable gland
-
with relay module 1x cable entry M20x1.5; 1x blind stopper
M
20x1.5 (cable gland M20x1.5 is attached)
Screw terminals for wire cross-section up to 1.5 mm²
(0.0023 in²)
Voltage supply
Supply voltage 20 … 253 V AC, 50/60 Hz, 20 … 72 V DC (at
U >
60 V DC, the ambient temperature can be
max. 50 °C/122 °F)
Power consumption 1 … 9 VA (AC), approx. 1.5 W (DC)
24 VEGAKON 66 - with relay output
Supplement
32649
-EN
-070615