VEGA VEGAVIB 62 Cable shortening set - Manual (Page 11)

11 Pull the cut cable (9) out of the upper part of the oscillator
(19).
Keep all parts for mounting.
7 9 12 10
Fig. 7: Sever the suspension cable (12) with a bolt cutter
7 Cable clamp
9 Cable
10 Perforated disc
12 Suspension cable
12 Cut the suspension cable (12) with a bolt cutter and keep
the perforated disc (10) for mounting.
13 Clean the remaining cable of the sensor (9) of oil and
grease and rub it off with talcum.
The old cable crimping cannot be used anymore and must
be correctly disposed of.
6 18 17 9 8 14 15 16 19 10 7
100 mm
(3 15 /
16
")
Fig. 8: Slide the parts onto the cable
6 Pins (4 pcs.)
7 Cable clamp
8 Mounting boss
9 Cable
10 Perforated disc
14 Pressure screw
15 Pressure ring
16 Rubber wrapping
17 Washer
18 Rubber rings (4 pcs.)
19 Upper part of the oscillator
VEGAVIB 62 • Cable shortening set 11
Mounting
30097
-EN
-080310