Kaiser S4571 User Manual
Page 9
9
EN
CONNECTING TO WATER SUPPLY AND
SEWERAGE NETWORK
Connecting the Aqua-Stop inlet hose
The inlet hose
equipped
with Aqua-Stop System
1
is provided with double walls.
The Aqua-Stop System ensures blocking of water
supply in case the inlet hose has broken as well as
if the air gap between the hose itself and its
corrugated shell is filled with water.
Connect the appliance to the water mains with new
hose sets only. Never reuse old hose sets.
Water pressure must amount to 0,04 MPa (min.)
and 1 MPa (max.). In case the pressure is below
the minimum value, consult the Service Centre.
Pull the inlet hose completely out from
storage compartment located at the back of
the dishwasher.
While adjusting to the faucet, tighten the
screw
2 of the safety inlet hose (3/4-inch
thread).
Before starting the dishwasher, turn on the
faucet against the stop.
Connecting cold water
Connect the cold water inlet hose to the threaded
3/4-inch connector. Make sure it is fastened tightly.
If the water pipes are new or have not been used
for an extended period of time, let the water run to
make sure that the water is clear and free of
impurities.
If this precaution is not taken, there is a risk that
the water inlet can get blocked and damage the
appliance.
2
1