VTech VM321-2 Manual - Manual (Page 32)

Parent unit settings
26
Vibration
You can set whether the parent unit vibrates whenever there is any
sound detected from the baby units. The vibration setting is preset to
On if speaker is off.
To change the vibration setting:
Press MENU/
SELECT
when the parent unit is not in use.
Press or to choose VIBRATION, then press
MENU
/SELECT or .
Press or to choose On if speaker is off, Always on or Off, then press
MENU
/SELECT to confirm your selection. You hear a confirmation tone.
Sound-activated screen
When the parent unit screen is turned off (see page 31), you can set
the screen to be turned on automatically whenever there are sounds
detected from the baby units. The parent unit screen will turn off
automatically when no sounds are detected from the baby units within
30 seconds. The sound-activated screen is preset to Off.
To turn the sound-activated screen on or off:
Press MENU/
SELECT
when the parent unit is not in use.
Press or to choose SOUND-ACTIVATED SCREEN, then press
MENU
/SELECT or .
Press or to choose On or Off, then press
MENU
/SELECT to confirm your
selection. You hear a confirmation tone.
The parent unit will turn on only if the sounds detected are from the last
viewed camera.
LCD brightness
You can change the brightness of the parent unit screen from Level 1
to Level 5. The LCD brightness is preset to Level 3.
To set the brightness of the parent unit screen:
Press MENU/
SELECT
when the parent unit is not in use.
Press or to choose LCD BRIGHTNESS, then press
MENU
/SELECT or .
Press or to choose the desired brightness.
Press
MENU
/SELECT to confirm your selection. You hear a confirmation tone.
1.
2.
3.
1.
2.
3.
1.
2.
3.
4.