VTech LS6195_-13-15-16-17 Manual - Manual (Page 8)

Getting started
4
Handset battery charging
Once you have installed the battery, the screen indicates the battery status (see the
table below). If necessary, place the handset in the telephone base to charge the
battery. For best performance, keep the handset in the telephone base when not in
use. The battery is fully charged after 11 hours of continuous charging. See the table
on page 59 for battery operating times.
If the screen is blank or displays
Put in charger, you need to charge the handset
without interruption for at least 30 minutes to give the handset enough charge to
use the telephone for a short time. When the battery is low, the handset displays
Low battery along with a flashing icon. If you are on a call in low battery mode,
the handset plays short beeps to alert you.
The following table summarizes the battery charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank, or
displays Put in charger and
flashes.
The battery has no or very
little charge. The handset
cannot be used.
Charge without interruption
(about 30 minutes).
The screen displays
Low battery and flashes.
The battery has enough
charge to be used for a
short time.
Charge without interruption
(about 30 minutes).
The screen displays
HANDSET X.
The battery is charged. To keep the battery charged,
place it in the telephone
base when not in use.
If you place the handset in the telephone base without installing a battery, the
screen displays No battery.
After you install your telephone or power returns following a
power outage, the handset will prompt you to set the date and
time. For instructions, see Set date and time on page 13.
To skip setting the date and time, press OFF/CANCEL.
Date: MM/DD/YY
ANS ON ECO