VTech CS6609 Manual - Manual (Page 2)

If the handset will not be used for a long time, disconnect and remove the battery
to prevent possible leakage.
To purchase a replacement battery, visit our website at www.vtechphones.com or
call (800) 595-95. In Canada, go to www.vtechcanada.com or dial
(800) 67-7377.
•
•
Battery installation
Install the battery as shown below.
Plug the battery connector securely
into the socket.
. Place the battery with the label
THIS SIDE UP facing up and
the wires inside the battery
compartment.
.
Slide the battery compartment cover
towards the center of the handset until
it clicks into place.
3. Place the handset in the telephone
base or charger to charge.
.
CHARGE light
remains on when
charging.
Battery charging
Once you have installed the battery, the screen indicates the battery status
(see the table below). For best performance, keep the handset in the telephone
base or charger when not in use. The battery is fully charged after hours of
continuous charging.
Battery indicators Battery status Action
The screen is blank, or
displays Put in charger
and flashes.
The battery has no or very little
charge. The handset cannot
be used.
Charge without interruption
(at least 30 minutes).
The screen displays
Low battery and flashes.
The battery has enough charge
to be used for a short time.
Charge without interruption
(about 30 minutes).
The screen displays
HANDSET X.
The battery is charged. To keep the battery
charged, place it in the
telephone base or charger
when not in use.
If you place the handset in the telephone base or charger without plugging in the
battery, the screen displays NO BATTERY.
Parts checklist
Your telephone package contains the following items. Save your sales receipt and
original packaging in the event warranty service is necessary.
Battery Charger and
charger adapter
Handset User’s manual
User’s manual
Battery compartment
cover