VTech DS6472-6 Manual - Manual (Page 111)

106
Appendix
Add and register a headset
This telephone system accommodates up to two cordless headsets. You
can buy an additional cordless headset ( IS6100, purchased separately) for
the telephone base. You can register a maximum of two headsets to the
telephone base. The telephone base recognizes and counts a headset the
same as a handset. The headset must be registered with the telephone base
before use. You may need to charge the headset before registering it to the
telephone base. For more details on battery charging, see page 6.
To register a headset:
Place the non-registered headset in the headset charger and allow it to
charge for at least 15 minutes before beginning registration. Remove the
headset from the headset charger. The light on the headset flashes
slowly and alternately in red and blue.
On the telephone base, press and hold
/FIND HANDSeT for about four
seconds until the red IN USe light turns on.
Immediately place the headset in the headset charger. It takes about
60 seconds to complete the registration. The red IN USe light on the
telephone base turns off. The light on the headset turns red when
it is registered but not fully charged, or turns blue if it is registered and
fully charged.
If the registration process is successful, you hear a dial tone when you press
on the headset. If the registration fails, you hear “ Not registered ” through
the headset earpiece when you press on the headset. The light on the
headset flashes slowly and alternately in red and blue. To reset the headset,
remove it from the headset charger and then place it back into its charger. Try
the registration process again.
1.
2.
3.
You cannot register a headset if any other system handset or headset is
in use.
The headset must be deregistered before registering it to another
telephone system.
•
•