VTech SN6167 Manual - Manual (Page 4)

Add and register a pendant
When first purchased, charge the pendant in the pendant
charger. You hear three beeps every 0 seconds when
the pendant is not registered. The new pendant should be
charged without interruption for at least 30 minutes before
registering it to the telephone base.
Make sure the pendant is out of the pendant charger and
turned on.
To register a pendant to your SN1157/SN1197/
SN6147/SN6197 telephone base:
Press MENU on the telephone base
when idle.
Scroll to
Settings, then press SELECT .
Scroll to Registration, then
press SELECT . The telephone base
shows Registering... Please wait.
Put the pendant in the pendant
charger. The pendant status light
flashes red and green to indicate
the registration is in progress. Then
PENDANT Registered appears
on the telephone base, and both devices beep. The
pendant is now registered with the telephone base. It
takes up to 60 seconds to complete registration.
If you have already set the photo speed dial keys
1 and
2, the telephone base displays Copied Photo Speed
Dial 1 to Pendant memory 1. Press NEXT , then the
telephone base displays Copied Photo Speed Dial 2 to
Pendant memory 2. Then press OK .
-OR-
If you have not set the photo speed dial keys
1 and 2,
see To set photo speed dial in the Abridged user’s
manual to set them.
If registration fails, the telephone base displays
Registration failed and you hear an error tone.
Start again from Step above.
To register a pendant to your SN6127/SN6187
telephone base:
Press and hold /FIND HANDSET at
the side of the telephone base until the
IN USE light turns solid red.
Put the pendant in the pendant charger.
The pendant status light flashes red and
green to indicate the registration is in
progress. The pendant beeps. Then it
is registered with the telephone base.
It takes up to 60 seconds to complete
registration.
If registration fails, you hear an error
tone. Start again from Step above.
.
.
3.
.
.
.
.