VTech SN6167 Manual - Manual (Page 3)

3
Pendant battery charging
The pendant light indicates the battery status. If necessary,
place the pendant in the pendant charger to charge. The
battery is fully charged after three hours of continuous
charging.
Battery indicators Battery status Action
The pendant light
flashes red. You hear
“Low battery” when
there is only 30 minutes
talk time left. You hear
an alert tone every
minute.
The battery has
very little charge.
Charge without
interruption.
The pendant light is
solid red.
The battery has
enough charge
to be used for a
short time.
Charge without
interruption.
Pendant attachment
Pendant lanyard:
The pendant lanyard is already attached to the pendant.
You can adjust the length of the lanyard for comfortable
wearing, or remove the necklace when necessary.
Pendant belt clip:
Remove the necklace of the pendant lanyard or the whole
pendant lanyard before you use the pendant belt clip.
Push the pendant into the belt clip until it clicks in place.
Press down the tabs
on both sides of
the lanyard clip to
remove the necklace
of the lanyard.
Press down on the
push button slider
to adjust the length
of the lanyard for
comfortable wearing.
Necklace