VTech TR27-2013 Manual - Manual (Page 7)

3
Getting started
Place the battery with the label
THIS SIDE UP facing up and
the wires inside the battery
compartment.
2. Plug the battery connector securely
into the socket, matching the
orientation of the engraved label.
1.
Slide the battery compartment cover
towards the center of the handset
until it clicks into place.
3. Place the handset in the telephone
base or charger to charge.
4.
Battery installation
Install the battery as shown below.
If the handset will not be used for a long period of time, disconnect and remove the
battery to prevent any possible leakage.
To purchase replacement batteries, visit our website at
www.vtechphones.com
or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or
call 1 (800) 267-7377.
•
•
IMPORTANT:
Check for a dial tone by pressing . If you hear a dial tone, the installation is successful.
If you do not hear a dial tone:
Make sure the installation procedures described above are properly done.
It may be a wiring problem. If you have changed your telephone service to
digital service from a cable company or a VoIP service provider, the telephone line
may need to be rewired to allow all existing telephone jacks to work. Contact your
cable/VoIP service provider for more information.
•
•
Charger
adapter CHARGE light
remains on
when charging.
Batter
y Pa
ck / Bloc
-piles
:
(2.4V Ni-MH
)
W A RNING /
AV
ERTISSEMENT
:
DO NO
T BURN OR PUNC
TU
RE
B AT
TERIES
.
NE P
AS INCINÉRER OU PERCER LES PILES.
Made in China /
Fa briqué en chine
TH
IS
S
ID
E
U P
/ C
E CÔ
TÉ
V
ER
S
LE
H
AU
T
CR1232
Batter
y P
ack / Bloc
-piles
:
(2.4V Ni-MH)
W A RNING / A
VERTISSEMENT
:
DO NO
T BURN OR PUNC
TU
RE
B AT
TERIES.
NE
PA
S INCINÉRER OU PERCER LES PILES.
Made in China / F
abriqué en chine
TH
IS
S
ID
E
U P
/ C
E
CÔ
TÉ
V
ER
S
LE
H
AU
T
CR1232