VTech FS6224_-2-21-3 Abridged manual - Manual (Page 3)

3
Battery charging
Once you have installed the battery, the screen indicates the battery status (see
the table below). For best performance, keep the handset in the telephone base
or charger when not in use. The battery is fully charged after 2 hours of
continuous charging.
Battery indicators Battery status Action
The screen is blank, or
displays Put in charger
and flashes.
The battery has no or very little
charge. The handset cannot
be used.
Charge without interruption
(at least 30 minutes).
The screen displays
Low battery and
flashes.
The battery has enough charge
to be used for a short time.
Charge without interruption
(about 30 minutes).
The screen displays
HANDSET X.
The battery is charged. To keep the battery charged,
place it in the telephone base
or charger when not in use.
Slide the battery compartment cover
towards the center of the handset until
it clicks into place.
3. Place the handset in the telephone
base or charger to charge.
4.
Battery installation
Install the battery as shown below.
Plug the battery connector
securely into the socket.
. Place the battery with the label
THIS SIDE UP facing up and
the wires inside the battery
compartment.
2.
Wall mounting (optional)
Your telephone comes ready for tabletop use.
To mount your telephone on the wall:
Position the top hole at the back of the telephone base against the top mounting
stud on the wall plate.
Align the holes on the telephone base against the mounting studs on the wall
plate. Then slide the telephone base down until it locks into place.
.
2.
Telephone base
Mounting studs