VTech LS6405 Manual - Manual (Page 7)

Getting started
4
Add and register a handset
You can add new handsets ( LS6405, purchased separately) to your telephone
system. Each handset must be registered with the telephone base before use.
When first purchased, each handset displays Put HS on BASE to register. You
may need to charge the handset before registering it to the telephone base. For
more details on battery charging, see page 3.
To register a handset:
Make sure the handset is out of the telephone base
or handset charger and shows
Put HS on BASE to register and then place the
handset in the telephone base.
The handset displays
Registering...Please wait and
the red IN USE light on the telephone base turns on. It
takes about 90 seconds to complete the registration
process. The handset displays
HANDSET X Registered (X represents the registered
handset number). The IN USE light turns off and the
handset beeps when registration completes.
If registration fails, the system will automatically try to
register again. If registration fails after the third try, the
handset displays Registration failed then
Put HS on BASE to register. This may take up to five
minutes to occur.
To reset the handset, remove it from the telephone base.
When the handset displays Put HS on BASE to register,
try the registration process again.
After registration, the date and time need to be reset.
1.
2.