Appendix, 12 energy-saving charging mode – VTech LS6405 Manual User Manual

Page 15

Appendix

Energy-saving charging mode

When first purchased and properly installed for charging (see

Battery installation on page 2), put the

handset in the handset charger to charge. The energy-saving charging mode is activated

while charging.
When this mode is activated, all telephone functions, except handset battery charging,

will be disabled.
If you have registered the handset to the

LS6425/LS6426/LS6475/LS6476 base, follow the instructions

below to activate and deactivate the energy-saving charging mode.
To activate the energy-saving charging mode:

Unplug the telephone base power adapter from the power outlet. Make sure all handsets are

plugged with charged batteries before proceeding.
While you press and hold

/FIND HANDSET, plug the telephone base power adapter back to the

power outlet.
After about 20 seconds, when the

IN USE light starts flashing, release /FIND HANDSET and

then press it again within 2 seconds.

When the phone successfully enters the energy-saving charging mode, the

IN USE light turns

off and all handsets display

Put HS on BASE to register.

When the phone fails to enter this mode, repeat Step 1 through Step 3 above.

Note: The telephone base will be powered up as normal if you fail to press /FIND HANDSET within

2 seconds in Step 3.
To deactivate the energy-saving charging mode:

Unplug the telephone base power adapter from the power outlet, then plug it back in.

Then the telephone base is powered up as normal.
Register your handsets back to the telephone base. See page 4 for handset

registration instructions.