VTech LS6305 Manual - Manual (Page 7)

Getting started
Add and register a handset
Each newly purchased handset ( LS6305) must be registered to the
telephone system ( LS6315/LS6325/LS6305) before use. When first
purchased, each handset shows 1.Press FIND hS on base 4sec and
2.Then press # on handset alternately. You may need to charge the
handset before registering it to the telephone base. For more details on
battery charging, see page 3.
To make registration easier, read all of the instructions on this page before
you begin.
To register a handset:
Place the unregistered handset in the telephone base or charger. If
1.Press FIND hS on base 4sec and 2.Then press # on handset do not
appear alternately on the handset screen after a few seconds, remove the
handset and place it in the telephone base or charger again.
On the telephone base, press and hold
/FIND hANDSeT for about four seconds until the red
IN USe light on the telephone base turns on.
Remove the handset from the telephone base or charger
and then press #. It displays registering...Please wait.
It takes about 10 seconds to complete the registration.
The handset shows hANDSeT X registered and you
hear a beep when the registration completes.
When the registration is complete, the newly registered
handset is assigned the next available handset registration
number. For instance, if you already have hANDSeT 1, the
next registered handset will be hANDSeT 2.
1.
2.
3.
If the registration fails, the handset displays registration
failed for a few seconds, then 1.Press FIND hS on
base 4sec and 2.Then press # on handset alternately.
To reset the handset, remove it from the telephone base
and place it back in. Try the registration process again.
You cannot register a handset if any other system
handset is in use.
Only one handset can be registered at a time.
•
•
•
4