Philips HB591 - Manual (Page 7)

7
6 The lamps and/or starters of the couch and the canopy can in principle be replaced in the same way.The starters are located at one of
the lamp ends, except for three starters in the canopy which are located in a different place and which can only be replaced by
removing the three lamps.
7 To remove the lamps, turn them to the left or to the right so that you can lift them out of their holders.
8 The starters can be removed by turning them to the left.
9 Insert new lamps and/or starters and follow the instructions above in reverse direction and order to reassemble the appliance.
10 Do not forget to fasten the end cover with the screws again.
◗ NB: the HPA lamps of the facial tanner may only be replaced by a service centre authorised by Philips.
Coin box or remote control unit
This appliance can also be connected to a coin box or a remote control unit.These devices may only be connected by a registered electrician.
The connection instructions can be found on a sticker on the power supply unit.
Environment
◗ Do not throw the appliance away with the normal household waste at the end of its life, but hand it in at an official collection point for
recycling. By doing this you will help to preserve the environment (fig. 21).
The lamps of this appliance contain substances that may pollute the environment. Always remove them and take them to an official collection
point before you hand the appliance in for recycling.
Guarantee & service
If you need service or information or if you have a problem, please visit the Philips Web site at www.philips.com or contact the Philips
Customer Care Centre in your country (you will find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre
in your country, turn to your local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care BV.
Guarantee restrictions
The following parts are not covered by the terms of the international guarantee.
-
tanning lamps
- acrylic sheets and the costs of cleaning acrylic sheets
ENGLISH
Possible causes
The mains plug has not been properly inserted into the wall socket.
The timer has not been set.
Connecting cables (J) have not been plugged in (correctly).
Check the fuses.The correct fuse type is a 16A standard fuse or an automatic fuse.
You are using an extension cord that is too long or does not have the correct current rating.
Consult your dealer. Our general advice is not to use an extension cord.
You are not following the tanning schedule suitable for your skin type. Check the table in
'Tanning sessions: how often and how long?'
When the lamps have been used for a long time, the UV light emitted will decrease.This effect
only becomes noticeable after several years.You can solve this problem by selecting a slightly
longer tanning time or by replacing the lamps.
Problem
The appliance does not start.
One or more fuses of the three-phase power supply system
cut off the power when you switch the appliance on or when it
is in use.
Poor tanning result.
Troubleshooting
If the appliance has not been installed or is not used in accordance with the instructions, it may fail to work properly. In that case you will be
able to solve the problem yourself by following the troubleshooting tips below.
If the problem is not mentioned in the list, the appliance may not work properly because it has a defect. In that case we advise you to contact
your dealer or a Philips service centre.