V-Tech AT16_D4 Manual - Manual (Page 7)

4.3 NO Disturb Mode
4.4 Date and Time Setting
1. Select
setup
item on main menu page to enter setup
page,then use ▲ / ▼ button to select Installation...
item. A password will be asked before enter next
sub menu.the password is 2412, Input the password
by using ▲ / ▼ Button to increase / decrease the
value; use Button to select next digit, and press
button to return last page . After finish,press MENU
Button to confirm and enter the sub menu page.
2. Select Date and Time Set... item. Input date and
time by pressing the ▲ / ▼ Button to increase /
decrease the value and pressing Button to select
next digit,After finish,press
MENU Button to save
and exit.and press button to exit and unsave.
If you don't want to be disturbed (for example, at night), set this item is on(use /
button to choose on/off), any call from the outdoor station will be sent to the guard
center, and the guard person will tell the visitor that you do not want to accept the visit.
Time
Date 2 0 1 0 0 3 3 1
1 0 3 2 :
Alarm In/Out Delay -- 40
Date And Time Set ...
Room Address...
Other Settings...
Information...
Exit
4
4.5 Room Adress
Room adress is the number you input on door station
to call the user.
According to 4.4 , select
Room Adress... item, 4 digits
number are required for room adress.Input the number
by pressing ▲ / ▼ Button to increase / decrease the
value; use Button to select next digit.After finish,press
MENU Button to save and exit.and press button to
exit and unsave.
Room
6 6 6 6