Ohaus 311 CENT-O-GRAM BALANCE Manual - Manual (Page 3)

UNPACKING AND ASSEMBLY INSTRUCTIONS
The balance has been shipped with each component packed securely in a
protective, expanded polystyrene container. Follow these instructions and you
can assemble your balance in just a few minutes.
1. Remove the poly-container from the shipping carton and place it so that you
can see the base and specific gravity stand. See Figure 3.
2. Cut the strap and lift off the upper half of the poly-container. Remove the base
and specific gravity stand. Hold the base upside down. Insert the round, flat
end of the stand through the slot in the base. Rotate stand into position as
shown in Figure 4. Rotate it as soon as the round end clears the opening.
When the base and the specific gravity stand are upright, the OHAUS on the
stand must be facing down.
Figure 3. Base and Specific Gravity Stand in Container.
Figure 4. Base and Specific Gravity Stand out of Container.
3