Herman Miller Embody Chairs - User Adjustments - Manual

HermanMiller Embody ® Chair Adjustment Guide 1
Seating that
performs for you.
HermanMiller
Embody
®
Chair
Seat Depth: Front handles on the right and left sides of the seat
Seat Height: Joystick inside tilt tension knob, right side of chair
To increase or decrease depth:
Lift your thigh weight from the front
of the seat. Gently lift up the front
handles on the right and left sides of
the seat to disengage the locking seat
depth adjustment. Slide seat forward
or back into proper depth for use; then
release downward to lock the seat.
In the proper position, you will have approximately three-fingers of clearance
between the back of your knees and the seat edge.
Only available on some models.
To raise seat:
Angle the joystick fully and lift your
weight to raise the seat height to the
desired level.
To lower seat:
While seated, angle the joystick fully
and lower seat.
At the proper height, your feet should rest flat on the floor.
Tilt Limiter: Back horizontal tab on left side behind seat
Tilt Tension: Knob below right side of seat
Only available on some models.
To engage:
Recline and move tab up to define
the limit of recline.
To release:
Lean forward and flip tab fully
downward.
Engage the tilt limiter when you want to sit in an upright or partially
reclined position.
To increase tension:
Turn knob clockwise.
To decrease tension:
Turn knob counterclockwise.
Set the tilt tension to control the resistance you feel when leaning back.