SINBO SCM 2625 - Manual (Page 14)

- 13 -
BEFORE THE FIRST USE
Note:
1) The carafe has the cup marks, the maximum tank capacity is equal to 4 cups marks
water quantity. The minimum tank capacity is equal to 2 cups marks water quantity.
2) Before pouring the water into the water tank, be sure the power cord is unplug from
the power outlet and the steam knob is in the
OFF
RELEASE position.
2. Replace the tank cover in place by turning the cover in clockwise until it locks in
position.
3. Put the steel mesh into metal funnel, add coffee powder to steel mesh with measuring
spoon, a spoon coffee powder can make about a cup of top-grade coffee. Then press the
coffee powder tightly with the tamper.
Note: Select your desired coffee powder to make desired cups coffee, the steel mesh
has 2 cups and 4 cups marks.
4. Make sure the tubers on the funnel align with the grooves in the appliance, then insert
the funnel into from the “INSERT” position, and
you can fix the funnel into coffee maker firmly
through turn it anti-clockwise until it is locked
in the “LOCK” position (see Fig. 1).
5. Place the carafe on the removable shelf.
6. Plug the power cord into the outlet.
Turn the steam knob to position, and the
indicator is illuminated, wait for about 2 minutes,
there will be coffee flowing out.
7. After desired coffee has obtained, you should
turn steam knob to PAUSE position, the indicator go
out and the coffee maker stops working, your
coffee is ready now. Then remove the carafe and
turn the steam control knob to
OFF
RELEASE position release the residual steam in the tank.
WARNING: Do not leave the coffee maker unattended during making the coffee, as you
need operate manually sometimes!
8. Before removing steel mesh or opening the tank cover, make sure the pressure in the
tank shall be released. The method is turn the steam knob to the position firstly, the
steam in the tank will eject from the frothing device. After pressure has released, and
wait for the steel mesh cooling down, you can remove the steel mesh or open the tank
cover.
9. After finishing making the coffee, you can take the metal funnel out through turn
clockwise, and then pour the coffee residue out with the steel mesh pressed by press
bar. Let them cool down completely, then rinse under running water. (When assemble
the steel mesh again, you shall turn over the press bar to the original position)
PAUSE
OFF
RELEASE