MAXWELL MW-3021 VT - Manual (Page 8)

ENGLISH
8
Iron
Description
1. Water spray nozzle
2. Water inlet lid
3. Water spray button
4. Constant steam supply knob
5. Additional steam supply button
6. Pilot lamp
7. Handle
8. Power cord protection
9. Base
10. “MAX” water level mark
11. Temperature control knob
12. Self-clean button
13. Water tank
14. Soleplate
15. Beaker
SAFETY MEASURES
Before using the unit, read these instructions
carefully. Keep these instructions for future
reference.
• Before using the unit for the first time, make
sure that voltage in your mains corresponds
to the unit operating voltage.
• Power cord is equipped with “euro plug”;
plug it into the socket with reliable ground-
ing contact.
• In order to avoid fire do not use adapters for
plugging the unit in.
• In order to avoid network overloading provide
that no other electrical appliances with high
power consumption are connected to the
same outlet the unit is connected to.
• Use the iron only for the intended purposes,
specified in the instructions.
• Do not use the unit outdoors.
• Place the iron on a flat stable surface or use
the ironing board.
• Never leave the operating unit unattended.
• Always unplug the unit if you do not use it.
• Always take the plug out of the socket when
filling the water tank with water.
• Water inlet lid should be closed during iron-
ing.
• Do not fill the water tank with scented liquids,
vinegar, starch solution, descaling reagents,
chemical agents etc.
• Avoid contact of open skin areas with iron hot
surfaces or outgoing steam in order to avoid
getting burns.
• Provide that the power cord does not hang
over the edge of the ironing board and make
sure that it does not touch hot surfaces.
• Before plugging/unplugging the unit, set the
temperature control knob to the “MIN” posi-
tion, and the constant steam supply knob to
the “0” position.
• To unplug the unit always pull its plug, but not
the power cord.
• In order to avoid electric shock do not
immerse the unit into water or other liquids.
• Before taking the iron away, pour out the
remaining water and let the unit cool down.
• Pour out water only after unplugging the iron.
• Do not use the iron if the plug or the power
cord is damaged or if there are other dam-
ages in the unit.
• Do not use the iron after dropping, in case of
visible damage or leaking.
• In order to avoid electric shock do not dis-
assemble the iron by yourself. If there are
some damages in the unit unplug the iron
and apply to the authorized service center.
• For children safety do not leave polyethylene
bags, used as a packaging, unattended.
• Attention! Do not allow children to play
with polyethylene bags and film. Danger
of suffocation!
•
• Keep the unit out of reach of children.
• Never allow children to use the iron as a toy.
• Be especially careful if children or disabled
persons use the unit.
• This unit is not intended for usage by children
or disabled persons unless they are given all
the necessary instructions by a person who
is responsible for their safety on safety mea-
sures and information about danger that can
be caused by improper usage of the unit.
• Store the iron vertically in a dry cool place,
out of the reach of children.
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY.
MW-3021.indd 8 11.09.2012 14:13:29